Flyin Optronics' 10Gigabit SFP+ transceiver is designed to transmit and receive optical data over MMF/SMF . The SFP+ module electrical interface is compliant to SFI electrical specifications.

Flyin Optronics’ BIDI SFP+ Transceivers are Small Form Factor transceiver module. It designed expressly for high-speed communication applications that require rates up to 10.7Gbps,it designed to be compliant with SFF 8472 and SFP+ MSA. The module data link up to 10km or 40km in 9/125um single mode fiber. The optical output can be disabled by a LVTTL logic high-level input of Tx Disable. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner.

Flyin Optronics’s CWDM SFP+ transceiver is designed for SMF and operates at a nominal wavelength of CWDM wavelength. The transceiver consists of two sections: The transmitter section incorporates a DFB laser. And the receiver section consists of a PIN photodiode integrated with a TIA. All modules satisfy class I laser safety requirements. Digital diagnostics functions are available via a 2-wire serial interface, as specified in SFF-8472, which allows real-time access to device operating parameters such as transceiver temperature, laser bias current, transmitted optical power, received optical power and transceiver supply voltage.

Flyin Optronics DWDM SFP+ transceivers are designed to transmit and receive optical data over single mode optical fiber. Digital diagnostic functions are available via an I2C.This module is designed for single mode fiber and operates at a nominal wavelength of ITU Grid, C Band DWDM wavelength. It is with the SFP+ 20-pin connector to allow hot plug capability. The transmitter section uses a DWDM EML laser and is a class 1 laser compliant according to International Safety Standard IEC-60825.The receiver section uses a PIN detector and a limiting post-amplifier IC.